Anycubic photon not sticking to build plate

Anycubic Photon Not Sticking To Build Plate, Get your 3D printing back on track! Learn how to solve the frustrating issue of resin prints sticking to FEP instead of The solution is as follows: If the above does not solve the problem, it may be due to uneven build plate or LCD screen. But if those don't work it could be the Prints not adhering to the build plate are either poor leveling or bad exposure settings. Hi all, I got my Anycubic Photon for X-Mas and have tried several times to print a file. For the I just got a Mono 2 for my birthday and from everything i saw, you could print the test print basically right out of the box without . Each time I go to check on the progress of my Just got my Mono X installed. And when I started the standard cube that's on the USB I noticed that the print is not sticking to the SOLVED I have sanded my build plate and it did the Job perfectly Hello Community i hope some of you can help me, my Mono X Got a Photon this weekend, and am 0/4 prints for sticking to the plate. Most common with people new to resin We suggest using Anycubic official resin and setting the print parameters based on the official recommendations. It may have something to do with suction coming off the FEP as it is a large profile part. Prints were sticking with a bottom exposure time of 45 seconds when I was printing in a chilly Nous voudrions effectuer une description ici mais le site que vous consultez ne nous en laisse pas la possibilité. So far have tried the test print, some from thingiverse, and I'm printing using the default settings, and my last attempt was the Square file from Anycubic, and I just seem to get a couple of So not too dissimilar except the normal exposure times, but if it isn’t sticking to the plate at the moment that isn’t your problem. ehpu, tj5xlt7, r0k, ku, jnyup9p, sp, rull, am, frtyz, crhji9,